Torque Specs For Freightliner Rod Tmr536

Set a torque wrench to 350 lbf·ft (475 n·m) and tighten the caliper mounting bolts following the tightening pattern shown in fig. For now i just torqued it to 135ftlb. Tighten in a diagonal pattern as shown in fig.

Torquespecsforfreightliner dawnlave

What is the torque spec for the rear axle hub flange. If they do not turn, no further work is needed. I just put in new spring bushing and want to.

• Essential Guide To Urban Survival Gear For Modernday Preparedness
• The Sweet Festivities Holidays Associated With Candy
• Ian Harding A Stars Journey Through Art And Activism
• Doraemon Movie Nobitas Night Before The Wedding Ndash A Heartwarming Tale Of Friendship And Adventure
• Kat Timpf The Intriguing Story Of Her Inheritance

This technical bulletin provides instructions to check the torque and, if required, tighten the tie rod end castle nuts on fh941kx15, fh941kx16, fh941kx17, fh946kx22 and fh946kx36.

They are 7/8 x 14 tpi (maybe 16). Tighten in a diagonal pattern as shown in fig. To avoid unnecessary damage during installation, it is advised that the installer research, and install to, the torque requirement for the terminal screws that hold down the wire harness on. Browse through and download our detroit spec sheets.

Looking for more information about freightliner truck engine specifications?

Torquespecsforfreightliner dawnlave

The Detroit™ DD13® Diesel Engine Demand Detroit Freightliner Trucks

The Detroit™ DD16® Diesel Engine Demand Detroit Freightliner Trucks

Freightliner Torque Rod, TMR536